SNL 3036 TURT

SNL plummer (pillow) block housings in the 30, 31 and 32 series are robust and suitable for tough operating conditions.

They enable the incorporated bearings to achieve maximum service life with less need for maintenance. Different housing variants and seal designs are available, making the use of tailored housings virtually unnecessary and enabling cost-effective bearing arrangements to be made

• Easy to install
• Cost-effective bearing arrangement
• Reduce maintenance
• Minimize lubricant leakage

Dimensions

BEARING SEAT

Da	280 mm	Diameter of bearing seat
	G7	Tolerance class of bearing seat diameter
Ca	108 mm	Width of bearing seat
H1	170 mm	Centre height of bearing seat

OUTSIDE DIMENSIONS

A1	180 mm	Foot width
A2	226 mm	Width across oil seals
G2	M8	Thread for condition monitoring
H	332 mm	Overall height
H2	70 mm	Foot height
L	510 mm	Overall length
J	430 mm	Distance between attachment bolts
J1	100 mm	Axial distance between attachment bolts
N	34 mm	Length of attachment bolt hole (radial)
N1	28 mm	Width of attachment bolt hole
s	14 mm	Offset of bearing axis

OIL INLETS AND OUTLETS

PG	G 3/8	Oil inlet for oil bath lubrication
QG	G 1/4	Oil inlet for circulating oil lubrication
RG	G 1	Oil outlet
R1	210 mm	Distance between oil outlets
R2	34 mm	Distance from housing bottom to oil outlet

DOWEL PINS

J6	470 mm	Distance between dowel pins
N4	20 mm	Diameter of dowel pins

Calculation data

BREAKING LOADS

P0°	1 700 kN	Breaking load at 0° load angle
P55°	2 100 kN	Breaking load at 55° load angle
P90°	1 000 kN	Breaking load at 90° load angle
P120°	760 kN	Breaking load at 120° load angle
P150°	680 kN	Breaking load at 150° load angle
P180°	850 kN	Breaking load at 180° load angle
Pa	550 kN	Breaking load, axial

YIELD POINTS OF CAP BOLTS

Q120°	1 800 kN	Load to reach yield point at 120° load angle
Q150°	1 040 kN	Load to reach yield point at 150° load angle
Q180°	900 kN	Load to reach yield point at 180° load angle

Materials

Housing material	Cast iron
Corrosion protection	Paint – in accordance with ISO 12944-2, corrosivity category C2

Mounting information

Recommended diameter of attachment bolts	G	24 mm
Recommended tightening torque for attachment bolts		665 N·m
Size of cap bolts		M24x140
Tightening torque for cap bolts		350 N·m
Size of eye bolt		M16
Oil level, max.	h	54 mm
Oil level, min.	h	48 mm

Included products

Breather plug

TSFT/N 3/8