7022 CD/P4ADGA
Matched set of two super-precision, high-capacity, D design, single row angular contact ball bearings
These matched sets of two super-precision, high-capacity, D design, single row angular contact ball bearings are available in a variety of arrangements.
They are designed for high-load capacity and relatively high speed operation and, compared to the equivalent SKF B and E design high-speed bearings, are best suited for heavier loads.
- Very high running accuracy
- Very high load carrying capacity
Dimensions
| d |
110 mm
|
Bore diameter |
| D |
170 mm
|
Outside diameter |
| B |
56 mm
|
Width |
| d1 |
128.5 mm
|
Shoulder diameter of inner ring (large side face) |
| d2 |
128.5 mm
|
Shoulder diameter of inner ring (small side face) |
| D1 |
151.5 mm
|
Shoulder diameter of outer ring (large side face) |
| r1,2 |
min.2 mm
|
Chamfer dimension |
| r3,4 |
min.1 mm
|
Chamfer dimension |
Abutment dimensions
| da |
min.119 mm
|
Diameter of shaft abutment |
| db |
min.119 mm
|
Diameter of shaft abutment |
| Da |
max.161 mm
|
Diameter of housing abutment |
| Db |
max.165 mm
|
Diameter of housing abutment |
| ra |
max.2 mm
|
Radius of fillet |
| rb |
max.1 mm
|
Radius of fillet |
| dn |
132.6 mm
|
Position of oil nozzle |
Calculation data
| Basic dynamic load rating |
C |
178 kN
|
| Basic static load rating |
C0 |
216 kN
|
| Fatigue load limit |
Pu |
7.8 kN
|
| Attainable speed for grease lubrication |
|
To be calculated: Single bearing (7500) x speed reduction factor (see table below)
|
| Attainable speed for oil-air lubrication |
|
To be calculated: Single bearing (12000) x speed reduction factor (see table below)
|
| Contact angle |
α |
15 °
|
| Ball diameter |
Dw |
19.05 mm
|
| Number of rows |
i |
2
|
| Number of balls (per bearing) |
z |
20
|
| Reference grease quantity (per bearing) |
Gref |
25.5 cm³
|
Preload and stiffness (back-to-back, face-to-face)
| Preload class |
|
A
|
| Preload |
G |
420 N
|
| Axial stiffness |
|
122 N/µm
|
Correction factors for preload calculation
| Correction factor dependent on bearing series and size |
f |
1.1
|
| Correction factor dependent on contact angle |
f1 |
1
|
| Correction factor, preload class A |
f2A |
1
|
| Correction factor for hybrid bearings |
fHC |
1
|
Factors for equivalent bearing load calculation
| Calculation factor for equivalent loads |
f0 |
15.5
|
