24052 CCK30/W33
Spherical roller bearing with tapered bore and relubrication features
Spherical roller bearings can accommodate heavy loads in both directions.
They are self-aligning and accommodate misalignment and shaft deflections, with virtually no increase in friction or temperature. The design includes features to facilitate relubrication. The bearings can be used in a modular system, including housings, sleeves and nuts.
- Accommodate misalignment
- High load carrying capacity
- Relubrication features
- Low friction and long service life
- Increased wear resistance
Dimensions
| d |
260 mm
|
Bore diameter |
| tΔdmp |
0.0 – 0.035 mm |
Deviation limits of mid-range bore diameter |
| tΔSL |
0.0 – 0.052 mm |
Deviation limits of tapered slope |
| D |
400 mm
|
Outside diameter |
| tΔDmp |
-0.04 – 0.0 mm |
Deviation limits of mid-range outside diameter |
| B |
140 mm
|
Width |
| tΔBs |
-0.1 – 0.0 mm |
Deviation limits of ring width |
| d2 |
≈289 mm
|
Shoulder diameter of inner ring |
| D1 |
≈347 mm
|
Shoulder/recess diameter of outer ring |
| b |
11.1 mm
|
Width of lubrication groove |
| K |
6 mm
|
Diameter of lubrication hole |
| r1,2 |
min.4 mm
|
Chamfer dimension |
|
Normal
|
ISO tolerance class for dimensions |
Abutment dimensions
| Da |
max.385 mm
|
Diameter of housing abutment |
| ra |
max.3 mm
|
Radius of fillet |
Calculation data
| SKF performance class |
|
SKF Explorer
|
| Basic dynamic load rating |
C |
2 135 kN
|
| Basic static load rating |
C0 |
3 450 kN
|
| Fatigue load limit |
Pu |
285 kN
|
| Reference speed |
|
1 000 r/min
|
| Limiting speed |
|
1 400 r/min
|
| Limiting value |
e |
0.33
|
| Calculation factor |
Y1 |
2
|
| Calculation factor |
Y2 |
3
|
| Calculation factor |
Y0 |
2
|
Tolerances of run-out
| Range of section height at inner ring of assembled bearing |
tKia |
13 µm
|
| Maximum run-out of inner ring side face to the bore |
tSd |
13 µm
|
| Range of section height at outer ring of assembled bearing |
tKea |
20 µm
|
| Perpendicularity of outer ring outside surface |
tSD |
6.5 µm
|
| ISO tolerance class for geometrical tolerances |
|
P5
|
Radial internal clearance
| Minimum initial clearance |
220 µm
|
| Maximum initial clearance |
300 µm
|
