Split plummer (pillow) block housing without bearing
SAF split plummer (pillow) block housings have a two-piece, cast metal construction with inch dimensions.
These housings have been developed to be the best choice for design, quality, robustness, and cost efficiency. SAF housings, when used with SKF bearings, seals and related components, provide a tailored solution to achieve maximum service life and reduce maintenance requirements for rotating equipment.
- Robust design
- Customizable configurations
- Suitable for tough operating conditions
- Cost-effective bearing solution
Dimensions
SHAFT
| da |
125.413 mm
|
Shaft diameter |
BEARING SEAT
| Da |
250 mm
|
Diameter of bearing seat |
|
G7
|
Tolerance class of bearing seat diameter |
| Ca |
77.8 mm
|
Width of bearing seat |
| H1 |
152.4 mm
|
Centre height |
OUTSIDE DIMENSIONS
| A1 |
149.225 mm
|
Foot width |
| A2 |
193.675 mm
|
Overall width |
| H |
305.594 mm
|
Overall height |
| H2 |
60.325 mm
|
Foot height |
| J |
min.396.875 mm
|
Distance between attachment bolts |
| J |
max.441.325 mm
|
Distance between attachment bolts |
| J1 |
85.725 mm
|
Distance between attachment bolts, axial |
| L |
511.175 mm
|
Overall length |
| N1 |
28.575 mm
|
Width of attachment bolt hole |
THREADED HOLES
| R1 |
87.313 mm
|
Distance of drain plug from centre |
| R2 |
38.1 mm
|
Height of drain plug position |
| RG |
3/4-14 NPT
|
Thread of drain hole |
| PG |
1/4-18 NPT
|
Thread of grease fitting in cap |
